Owner`s manual

Installation Preparation
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Duct tape
Pencilandtape measure
Spirit level
MetalSnips
Wirecutter/
stripper
Step ladder
Safetgglasses
Sabersaw
or Sawsall
Keg Hole Saw
Wire nuts
Flashlight
Electric or batterg operated
drill and !/8", 3/8" bits
!0" round
metal duct,
length to
suit installation.
Phillips and flat
blade screwdrivers @
Strain relief for
junction cover.
!20V 60Hz. 15 or 20 Amp,
2-wire with ground. Properlg
grounded branch circuit.
REMOVE THE PACKAGING
. Lift out the wooden crossmember, as well as the top
protective carton.
, Lift out the four "L" shaped polgstgrene protection profiles.
, Remove the protection moldings around the smaller
carton box.
, Remove the small box housing the motor.
, Lift the hood out of the box.
ACAUTION Lift the hood bg grasping
the outside edges of the inlet opening of the hood.
Do not lift the hood bg the exhaust opening divider--
damage will occur!
Wood
Mounting
Support
w ]
/ s t
Hood y;5'
/ /
|! ,5'
! Motor ', ,,',," Parts
u ,
I , , ,' Package
Shipping Carton
, Remove the shipping screws holding the wood
mounting piece to the back side of the hood.
Set aside the wood mounting piece and screws
for later installation. Do not discard.
, Remove the "V" shaped carton insert.
, Remove the parts package from the "V" shaped
cardboard insert.
, Remove the junction box cover and knockout.
, Install the strain relief onto the back or top of the hood.
, Remove all tape and packing material from the hood, duct
transition and motor.
49 80151 8 9