Spec Sheet

ManualsBrandsMonogram ManualsRange HoodsMonogram 460 CFM 36 Inch Wide Under Cabinet Range Hood

ZV800SJ/BJMONOGRAM 36" SLIDE-OUT HOOD

Listed by

Underwriters

Laboratories

Product Speciﬁcation Revised 1/18

13-11/16" at center

-15/16" at sides

1-1/2"

*Height to

Ceiling

35-7/8"

*The Supplied Duct Cover F

its

8 ft. to 10 ft. Ceiling Heights

NOTE

The vent hood canopy extends forward 5-7/8".

The vent hood must be installed 24" min., and 30" max.

above the cooking surface. The telescopic duct cover

conceals the ductwork running from the top of the hood

to the ceiling. The duct cover is sized to reach 8 ft. to 10 ft.

ceiling heights.

The hood installation height, from the cooking surface to

the bottom of the hood, depends upon ceiling height.

INSTALLATION INFORMATION

Before installing, consult installation instructions packed

with product, or available online at monogram.com, for

current dimensional data.

DIMENSIONS AND INSTALLATION INFORMATION

(IN INCHES)

Summary of content (4 pages)

PAGE 1
MONOGRAM 36" SLIDE-OUT HOOD ZV800SJ/BJ DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES) NOTE The vent hood canopy extends forward 5-7/8". The vent hood must be installed 24" min., and 30" max. above the cooking surface. The telescopic duct cover conceals the ductwork running from the top of the hood to the ceiling. The duct cover is sized to reach 8 ft. to 10 ft. ceiling heights. The hood installation height, from the cooking surface to the bottom of the hood, depends upon ceiling height.
PAGE 2
MONOGRAM 36" SLIDE-OUT HOOD WALL MOUNT INSTALLATIONS ZV800SJ/BJ INSTALLATION BELOW A CABINET These hoods may be installed onto a wall or below a wall cabinet. • Telescopic duct covers are provided to conceal the ductwork, running to the ceiling. • This hood can be installed for recirculation operation. No kits required. *20” Min. 24” Min. * The cabinet must measure at least 20" from the bottom frame to the inside top. The hood housing will occupy the interior cabinet space.
PAGE 3
MONOGRAM 36" SLIDE-OUT HOOD ZV800SJ/BJ CABINET REQUIREMENTS DUCTWORK, WIRING This hood may be installed beneath a wall-mounted cabinet. • Both vented and recirculating operation can be accomplished in an under-cabinet installation. • If the cabinet has been installed, it must be removed so that wall framing supports can be added. • Determine the exact location of the vent hood. • Locate the Rear Wall Template packed with the literature.
PAGE 4
MONOGRAM 36" SLIDE-OUT HOOD ZV800SJ/BJ FEATURES AND BENEFITS NDER-CABINET OR STAND-ALONE INSTALLATION U The chimney hood installs beneath a cabinet, above most cooktops and ranges. For a more contemporary look, the system can be wall-mounted with matching 8-to-10-ft.