ZV800

49-80267 Rev. 4 21
UNDER-CABINET INSTALLATION
Installation Instructions
3
CUT THE OPENING
,IWKHFDELQHWKDVEHHQLQVWDOOHGUHPRYHLWIURPWKH
wall.
Ŷ8VHWKH7RS&DELQHW7HPSODWHWRORFDWHDQGFXWD
hole in the bottom of the cabinet.
Ŷ,IQHFHVVDU\SODFHWKHWHPSODWHRQWRSRIWKH
cabinet to accurately cut a matching hole.
Ŷ,QVWDOOWKHFDELQHWRQWRWKHZDOO
The cabinet must be firmly secured to the wall
and be capable of supporting 100 lbs.
INSTALL WOOD BLOCKS IF NECESSARY
Ŷ,QVWDOOILOOHUEORFNVZKHQHYHUWKHFDELQHWIUDPH
hangs below the cabinet bottom.
Ŷ,QVWDOOILOOHUEORFNVZKHQHYHUWKHFDELQHWERWWRPLV
less than 3/4” thick.
Ŷ,QVWDOOWKHILOOHUEORFNVRQHDFKVLGHRIWKHFXWRXW
The filler blocks will accept the hood mounting
screws.
NOTE: $GGLWLRQDOILOOHUEORFNVPD\EHUHTXLUHGDORQJ
the outside edges to accept the outside screws. See
Step 5.
IMPORTANT: ,IILOOHUEORFNVDUHQRWXVHGWKHKRRG
may not be secured to the cabinet.
4
INSTALL SIDE “L” BRACKETS
Ŷ,QVWDOOWKH³/´EUDFNHWVRQWRHDFKVLGHRIWKH
cutout. The wide flat portion should be on top of
the opening. Install 2 screws into the top of each
bracket.
5
REMOVE SIDE SCREW
The top center screw on both sides of the hood
can be used to close up any noticeable gaps at the
outside edges. See illustration.
Ŷ5HPRYHWKHFHQWHUVFUHZFRYHUDQGVFUHZRQHDFK
side as shown.
&DELQHW)UDPH
Cabinet Bottom Shelf
)LOOHU%ORFN
Top of Vent
Hood
Equivalent
to Depth of
Cabinet Recess
Install 2 screws in each
bracket
Remove screw
cover and screw