Installation Guide

49-80267 Rev. 4 
Installation Instructions
WALL-MOUNTED INSTALLATION—RECIRCULATING
6
CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING
If house wiring is not 2-wire with
DJURXQGZLUHDJURXQGPXVWEHSURYLGHGE\WKH
LQVWDOOHU:KHQKRXVHZLULQJLVDOXPLQXPEHVXUH
WRXVH8/DSSURYHGDQWLR[LGDQWFRPSRXQGDQG
aluminum-to-copper connectors.
AVERTISSEMENT
Si la maison n’est pas câblee avec
GHX[ILOVHWXQILOGHWHUUHO¶LQVWDOODWHXUGRLWLQVWDOOHUXQILOGH
WHUUH4XDQGOHVILOVVRQWHQDOXPLQLXPLOIDXWSUHQGUHVRLQ
d’utiliser des connecteurs aluminium à cuivre avec une pâte
DQWLR[\GDQWHDSSURXYpHSDU8/
Ŷ5HPRYHMXQFWLRQER[FRYHUDQGNQRFNRXW
Ŷ8VHDFRQGXLWFRQQHFWRUWRVHFXUHWKHFRQGXLWWR
WKHMXQFWLRQER[
Ŷ&RQQHFWZKLWHOHDGVWREUDQFKFLUFXLWZKLWHOHDG
Ŷ&RQQHFWEODFNOHDGVWREUDQFKFLUFXLWEODFNOHDG
Ŷ&RQQHFWJUHHQ\HOORZOHDGVWREUDQFKFLUFXLWJUHHQ
lead or bare ground lead.
Ŷ6HFXUHDOOFRQQHFWLRQVZLWKZLUHQXWVRQHDFK
electrical connector.
Ŷ3XVKZLUHVLQWRMXQFWLRQER[DQGUHSODFHFRYHU%H
sure wires are not pinched.
Ŷ6HFXUHHOHFWULFDOSDQHOFRYHUZLWKRULJLQDOVFUHZV
7
INSTALL DUCT COVERS
Ŷ3ODFHWKHGHFRUDWLYHGXFW
covers on top of the hood.
NOTE: The inside piece has vent
holes on one end intended for
use when the hood is installed for
recirculating purposes. Be sure
the vented end is at the top; the
vent holes will be visible in this
installation.
The inside duct piece must slip
into the folded ends on the outer
section.
Ŷ([WHQGWKHLQQHUGXFWSLHFHXSZDUGVWRWKHFHLOLQJ
mounted air deflector.
Ŷ6HFXUHWKHGXFWFRYHUWRWKHDLUGHIOHFWRUGULYLQJ
one screw on each side.
Ŷ/RFDWHWKHVFUHZKROHVRQWKHERWWRPRXWVLGHHGJH
of the hood.
Ŷ6HFXUHWKHORZHUGXFWFRYHUWRWKHKRRGE\
installing 2 screws from the bottom of the hood into
the duct cover.
Mounting
screws
Vent
holes
Install
2 bottom
duct cover screws
,QVWDOOVFUHZV
duct cover and into
ceiling bracket