Installation Guide

 49-80267 Rev. 4
Installation Instructions
UNDER-CABINET INSTALLATION
1
INSTALL FRAMING FOR HOOD
SUPPORT
IMPORTANT:)UDPLQJPXVWEHFDSDEOHRIVXSSRUWLQJ
OEV
,IGU\ZDOOLVSUHVHQWPDUNWKHVFUHZKROHORFDWLRQVIRU
the top mounting brackets. Remove the template.
Ŷ&XWDZD\HQRXJKGU\ZDOOWRH[SRVHYHUWLFDOVWXGV
at the bracket location indicated on the template.
Ŷ,QVWDOODKRUL]RQWDOVXSSRUWDWOHDVW´[´EHWZHHQ
two wall studs at the mounting screw location. The
horizontal support must be flush with the room side
of the studs. Use cleats behind both sides of the
support to secure to wall studs.
Ŷ5HLQVWDOOGU\ZDOO
Centerline of
Installation
Space
View From Rear
Cleats
1" x 6" Min.
Mounting
Support
Centerline of
installation
space
View from rear
cleats
´[´PLQ
mounting
support
2
PREPARE THE HOOD
Ŷ5HPRYHWKHKRRGIURPWKHER[5HPRYHSDFNDJLQJ
and tape.
Ŷ5HPRYHRQHVFUHZRQHDFKVLGHRIWKHFRYHURQ
the electrical panel. Lift off the cover and set aside
with screws.
Ŷ6WDQGWKHHOHFWULFDOSDQHOXSULJKW
Ŷ$OLJQWKHVFUHZKROHVLQWKH
bottom of the panel with the
holes on the base of the
hood at the front side.
Ŷ,QVWDOOVFUHZVSURYLGHG
Remove 2 side
cover screws
Electrical
panel
Secure electrical
panel with 3
screws
-XQFWLRQER[
Inside screw