Owner's Manual

49-80403 Rev. 6 9
Problem Possible Cause What To Do
Fan automatically turns on and can
not be turned off
The Sensor feature will automatically turn the fan
on at the MED setting and the display will show
AUTO MODE ON if cooking temperatures become
too hot. The fan will stay on for a minimum of 3
minutes and will then turn off when temperatures
cool to an appropriate level.
Fan does not operate when turned
on
A fuse may be blown or a circuit
breaker tripped.
Replace fuse or reset circuit breaker.
The power disconnect switch inside the
hood may be
switched off.
Remove the metal grease filter and the charcoal
filter (if present) and flip the switch on.
Fan fails to circulate air or moves
air slower than normal
Check to be sure the metal grease filter and the
charcoal filter (if present) are clean. Clean the
metal grease filter (see the Metal grease filter
section) and, if the hood is recirculated (not vented
to the outside), replace the charcoal filter (see the
Charcoal filter section). If cleaning and replacing
the filters does not correct the problem, call for
service.
Sufficient makeup (replacement) air is
required for exhausting appliances to
operate to rating.
Check with local building codes, which may require
or strongly advise the use of makeup air. Visit
Monogram.com for available makeup air solutions.
Fan keeps going
off and on
The motor is probably overheating and
turning itself off. This can be harmful to
the motor.
Check to be sure the filter is clean. If it continues
to cycle on and off, call for service.
Light will not stay on high setting
or “wrong watt bulb” appears in
the display
Use 12 volt, 20 watt halogen bulbs with a G4 base
and make sure they are inserted securely. See the
Light bulbs section.
The hood controls or display are
not operating correctly
Disconnect power to the hood by removing the fuse
or turning the circuit breaker off in the home fuse
box. Wait 30 seconds to allow the hood controls to
reset and then replace the fuse or move the circuit
breaker back on.
Sequential presses of the light or
fan buttons will sometimes change
the setting from the lowest setting–
to off to the highest setting, or
from the highest setting–to off–to
the lowest setting
It is normal for the light and fan buttons to cycle
around through the settings so that you can easily
set the controls to the desired setting.
When pressing the power on/off
button to turn on the light, the fan
comes on instead
For your convenience, it is normal for the lights and
fan to remember their last setting when you press
the Power On/Off button. If you want only the lights
on, press the “FAN +” (or the “FAN –” ) button until
“Off” is in the display. When you power the hood up
next time, only the lights will function.
Save time and money! Review the charts on the following pages first and you may not need to call for service.
TROUBLESHOOTING