Specifications

MONOGRAM 30" CUSTOM HOOD INSERT ZVC30LSS
Product Specification Revised 1/18
Opening
Custom Insert Liner
The custom canopy must be sized to fit the
insert sleeve. Construct the canopy with an
opening that is: 26"W x 13-3/16"D
The opening must be constructed of 3/4" thick
material to allow the sleeve locking clips to
engage.
Dimensions and Specifications (in inches)
14"
27-1/2"
ZVC30 and ZVC36
Outside Dimensions
The Insert Sleeve
14"
16-3/4"
1/2"
ZVC30 and ZVC36
NOTE: Bottom edge of insert sleeve
has a 7/8" flange on each side and
a 1/2" flange on both front and back.
13"
25-3/4"
1/2"
7/8"
13"
The bottom edge of the insert sleeve has a
7/8" wide flange on the sides and a 1/2" wide
flange on the front and back.
Remote Location for the Control
The control may be removed from the hood
and installed into a wall or countertop. A 30-
ft length of wire is supplied to accommodate
most installations. A blanking plate covers the
opening when the controls are removed. The
overall size of the control is 4-1/4" wide and
2-1/4" deep.
3'-11/16"
1'-11/16"
Control Cutout
We recommend that the cutout in granite
or other hard surfaces be made before the
countertop is installed.
The Supplied Liner
A stainless steel liner is shipped with each
hood insert. This non-combustible liner
protects the underside of the canopy.
Custom Liner
If you are not using the supplied liner, you may
construct a custom non-combustible liner. Use
the supplied liner as a template. The opening
must be 26"W x 13-3/16"D. 3/4" thick material
must surround the opening to allow the sleeve
locking clips to engage. The insert sleeve inside
the cabinet should be positioned 1/2" from the
rear wall so that the center of the 8" duct is
5-1/2" from the rear wall.
4"
21-1/4"
1/2"
7-1/2"
1-1/4"
A stainless steel liner is shipped with each hood. This
non-combustible liner protects the underside of the
cabinet. A non-combustible custom liner may be
constructed to suit the installation.
Liner sizes
28-1/2"