Quick Specification

HELPFUL TIPS
A
Additional clearance between cut-outs
may be required. Check to be sure that
oven supports above the storage drawer
location do not obstruct the required
interior 23-1/2" depth and 5-7/8" height.
B
If you are installing in frameless cabinets,
it may be necessary to install 1/2" wide
cleats to accept drawer mounting screws.
See drawer for mounting screw locations.
C
Install an anti-tip block against rear
wall, 5 5/8" from oor of cutout to
bottom of block. The anti-tip block
must be installed to prevent the drawer
from tipping forward when opened and
loaded. Failure to add the anti-tip block
could result in personal injury.
D
When installing the storage drawer below
a cooktop, a solid barrier must be installed
at least 1" from the lowest point of the
bottom of cooktop burner box to the top
of the cut-out. Use any solid material
such as 1/4" thick plywood. Allow at least
1/4" air gap between the barrier and the
top of the storage drawer. Observe the
3/8" min. above the toe kick installation
height.
E
When installing two storage drawers side
by side, install them in separate
cut-outs and allow a 1-3/4" min. gap
between each cut-out.
For more details refer to the installation
instructions for this product.
A
INSTALLATION BELOW COOKTOP
STANDARD INSTALLATION
SIDE VIEW
C
5 5/8”
Anti-Tip
Block
1” Min
Bottom of
cooktop to
top of cutout
3/8” Min
From cutout to
top of toe kick
D
STANDARD INSTALLATION
FRONT VIEW
28 1/2”
Cutout width
B
SIDE BY SIDE INSTALLATION
1 3/8” Min
Between cutouts
E
For questions about your
appliance, please call 1-800-626-2000.
PAGE 4 OF 7 Product Specication Revised 9/21