User Manual

ManualsBrandsMonoprice ManualsMonoprice TV & VideoTitan Series Full Motion Wall Mount for Large 32- 60 inch TVs 175lbs Black

InstallationInstruction

English

UNPACKING INSTRUCTIONS

IMPORTANT SAFETY INFORMATION

Carefully open the carton, remove contents and lay out on cardboard or other protective surface to avoid damage.

Check package contents against the Supplied Parts List in the next page to assure that all components were received

undamaged. Do not use damaged or defective parts.

Carefully read all instructions before attempting installation.

Install and operate this device with care. Please read this instruction before beginning the installation, and carefully

follow all instructions contained herein. Use proper safety equipment during installation.

Please call a qualified installation contractor for help if you:

If you don't understand these directions or have any doubts about the safety of the installation.

If you are uncertain about the nature of your wall, consult a qualified installation contractor.

Do not use this product for any purpose or in any configuration not explicitly specified in this instruction. We hereby

disclaim any and all liability for injury or damage arising from incorrect assembly, incorrect mounting, or incorrect use of

this product.

CAUTION!

WARNING

This TV mount must be securely attached to the vertical wall. If the mount

is not properly installed it may fall, resulting in possible injury and/or

damage.

Note: The mounting components and hardware supplied in this package are not designed for installations to

walls with steel studs or to cinder block walls. If the hardware you need for your installation is not included,

please consult your local hardware store for proper mounting hardware for the application.

Tools Required

5/32"(4mm) Drill Bit

Phillips Screwdriver

3/8"(10mm) Masonry Bit

Stud Finder

Wrench or Socket Set

Carpenter's Level

Monoprice Adjustable Tilt Swivel Plat Panel Wall Mount

Model: PLB-110B-R (PID#8587/8588)

VESA Compliant up to 750x450

Max Weight: 175lbs

Summary of content (5 pages)

PAGE 1
English Monoprice Adjustable Tilt Swivel Plat Panel Wall Mount Model: PLB-110B-R (PID#8587/8588) VESA Compliant up to 750x450 Max Weight: 175lbs Installation Instruction UNPACKING INSTRUCTIONS ! Carefully open the carton, remove contents and lay out on cardboard or other protective surface to avoid damage. ! Check package contents against the Supplied Parts List in the next page to assure that all components were received undamaged. Do not use damaged or defective parts.
PAGE 2
Supplied Par ts List (1)Wall Plate-a (1)Left Monitor Bracket-b (1)Right Monitor Bracket-c (4)M4x12 Bolt-d (4)M5x12 Bolt-e (4)M6x12 Bolt-f (4)M8x16 Bolt-g (4)M4x30 Bolt-h (4)M5x30 Bolt-i (4)M6x35 Bolt-j (4)M8x40 Bolt-k (4)M5 Lock Washer-m (4)M6 Lock Washer-n (4)M8 Lock Washer-o (4)M4/M5 Space-p (4)M6/M8 Space-q (8)M4/M5 Washer-r (4)M6/M8 Washer-s (6)M8x90 Lag Bolt-t (6)Lag Bolt Washer-u (6)M10x8 0 Concrete Anchor-v (4)M4 Lock Washer-l Pls install the Plastic Knob on the Monitor Bracket
PAGE 3
Step 1A Mounting the Monitor Brackets to a TV with Flat Back First of all, make sure the diameter of the Bolt(d,e,f,g) your TV requires. Once you have determined the correct diameter, please see the relative diagram as below. You will thread the Bolt into the TV using the correct Lock Washer(l,m,n,o) and Washer(r,s). Please make sure the Monitor Brackets(b,c) are vertically centered and level with each other.
PAGE 4
Step 2 Mounting the Wall Plate to the Wall Brick, Solid Concrete mounting: Use the Wall Plate(a) as a template to mark 6 hole locations on the wall. Three in the top row of slots and three more in the bottom row. Make sure these holes are level and there is at least 6"(150mm) distance between any two holes. Pre-Drill these holes with a 3/8"(10mm) masonry bit to at least 3"(75mm) in depth. Insert a Concrete Anchor(v) into each of these holes.
PAGE 5
Step 4 Levelling Mount You can re-level the mount after the mount has been installed on the wall. Leveling is achieved by rotating the front plate the TV sits on. Needn’t to loose the 5 bolts on the front plate, just hold the TV and do the adjustment. See Diagram 4 below. Diagram 4 WARNING Use two people to lift and position the TV onto the Wall Plate. Thanks for choosing our products, enjoy the using.