Aluminum Dual Monitor Desk Stand 15" - 30" P/N: 13815 User's Manual
INTRODUCTION Thank you for purchasing this Dual Monitor Desk Stand! This desk stand is capable of mounting two 15 " ~ 30" monitors, with 75 x 75 or 100 x 100 VESA® mounting patterns and weighing up to 22 lbs. each. It allows for overall height, individual height, tilt, swivel, and horizontal adjustments, and includes cable management clips and all the hardware necessary to assemble the stand and mount two monitors.
PACKAGE CONTENTS Please take an inventory of the package contents to ensure you have all the items listed below. If anything is missing or damaged, please contact Monoprice Customer Service for a replacement. E A Arm Assembly C Pole Assembly B D G ø8.0 x ø5.5 x 5.
INSTALLATION 1. Place the Base (B) on a desk or table. 2. Insert the Pole Assembly (C) into the hole in the base, then turn it clockwise to tighten the connection. 3. Place the Arm Assembly (A) onto the Pole Assembly (C), adjust the height as desired, then use the 4mm Hex Wrench (G) to tighten the screw as shown in the following figure to the right. You can also adjust the height by loosening the lock collar and extending the pole assembly up or down as desired. 4.
6. Repeat steps 4 and 5 for the second monitor. 7. Place one of the monitors onto a mounting bracket by placing the extended screws into the grooves on the bracket. 8. Insert two (2) additional Short M4x12 Screws (E) or Long M4x12 Screws (F) through the bracket into the lower VESA® mounting holes. Tighten the screws to secure the bracket to the back of the monitor. Use the ø8.0 x ø5.5 x 5.0 mm Bushings (D) as necessary to reduce the space between the screw heads and the back of the monitor. 9.
10. Loosen the two thumbscrews that hold each bracket to the mounting arm, then slide the monitor and bracket assemblies so that the monitor bezels are almost touching at the center of the desk mount assembly, as shown in the figure to the right. Tighten the thumbscrews to secure the brackets in place. 11. If the monitors are not level, use the included 4mm Hex Wrench (G) to tighten the screw at the top of the lower bracket, thereby raising the bracket's level.
12. To adjust the tilt, first use the included 5mm Hex Wrench (H) to slightly loosen the two screws on each side of the mounting bracket, adjust the tilt as desired, then tighten the screws to secure the bracket in place. 13. To adjust the monitor angles, use the included 5mm Hex Wrench (H) to slightly loosen the two screws at the base of the arms, adjust the angle, then tighten the screws to secure the arms in place. 14.
TECHNICAL SUPPORT Monoprice is pleased to provide free, live, online technical support to assist you with any questions you may have about installation, setup, troubleshooting, or product recommendations. If you ever need assistance with your new product, please come online to talk to one of our friendly and knowledgeable Tech Support Associates. Technical support is available through the online chat button on our website www.monoprice.com during regular business hours, 7 days a week.
