User Manual

6
SAMPLE CONNECTION DIAGRAM
INSTALLATION
Perform the following steps to install this extender kit.
1. Ensure that all equipment to be connected is powered off and unplugged from its
power source.
2. Place or mount the receiver and transmitter in their intended locations.
3. Using a High Speed HDMI Cable (not included), plug one end into the HDMI® input
on your display, then plug the other end into the HDMI Out port on the Receiver.
4. (Optional) Using a 3-pin Euroblock connector (not included), construct an RS232
serial cable to connect to your computer or other RS232 enabled device. Plug the
Euroblock connector into the RS232 port on the Receiver, then plug the other end
into your RS232 enabled device.
5. (Optional) Plug an IR receiver (not included) into the IR In jack on the Receiver, then
position the receiving "eye" so that it can receiver infrared signals from your remote
control.