User Manual

3. (Optional) Using another XLR cable, plug one end into the XLR BALANCED INPUT on

another Monolith subwoofer, then plug the other end into the XLR DIRECT PASS-

THRU jack on the subwoofer.

4. Plug one end of the included AC power cable into the FUSE/120 VAC connector on

the subwoofer, then plug the other end into a nearby AC power outlet.

Warning! Due to the power requirements of the Monolith subwoofer, do not

connect to the accessory outlets on a receiver or processor. If using a power strip,

ensure that it is rated to accommodate the subwoofer's power requirements.

5. Plug in and power on all connected equipment.

6. Set the POWER switch on the subwoofer to the AUTO ON/OFF or ALWAYS ON

position, as desired.

7. Using the information in the

PRODUCT OVERVIEW

section, set the controls to the

desired starting positions, then adjust as needed.

Connecting to a Subwoofer/LFE Output

If your amplifier has a Subwoofer or LFE output, you can connect to the subwoofer using a

single, mono RCA cable. Perform the following steps to connect the subwoofer to a

dedicated subwoofer or LFE output on your receiver or amplifier. Note that any receiver

that can decode Dolby Digital or DTS soundtracks will have a dedicated subwoofer or LFE

output.

1. Power off and unplug all equipment to be connected.

2. Using a single, mono RCA cable, plug one end into one of the LFE & LINE

UNBALANCED INPUTS on the subwoofer, then plug the other end into the

dedicated subwoofer or LFE output on your receiver.

3. (Optional) Using an XLR cable, plug one end into the XLR BALANCED INPUT on

another Monolith subwoofer, then plug the other end into the XLR DIRECT PASS-

THRU jack on the subwoofer.

4. Plug one end of the included AC power cable into the FUSE/120 VAC connector on

the subwoofer, then plug the other end into a nearby AC power outlet.