CONTENTS INTRODUCTION ................................................................................................................................................................................................ 3 FEATURES .............................................................................................................................................................................................................. 3 PACKAGE CONTENTS ............................................................
INTRODUCTION Thank you for purchasing this Z-Wave Plus® RGB Smart Bulb! This RGB Smart Bulb is an AC powered Z-Wave enabled device and is fully compatible with any Z-Wave enabled network. Z-Wave is an interoperable, two-way RF mesh networking technology used for home automation and security. Every AC powered Z-Wave device acts as a signal repeater, so multiple devices result in more possible transmission routes, which helps eliminate RF "dead spots" in the network.
PACKAGE CONTENTS Please take an inventory of the package contents to ensure you have all the items listed below. If anything is missing or damaged, please contact Monoprice Customer Service for a replacement. 1x Z-Wave Plus® RGB Smart Bulb 1x User's Manual INSTALLATION Note: If you are installing a complete Z-Wave® system for the first time, please refer to the installation guide of your Z-Wave Interface Controller before installing this RGB Smart Bulb. 1.
4. Put the wall switch in the on position. 5. Auto-inclusion will begin. If successful, the RGB Smart Bulb will blink blue rapidly for 5 seconds, then will illuminate steadily blue for 3 seconds. It will then remain on in the default color (warm white). Secure Inclusion 1. Ensure that the wall switch is in the off position. 2. Screw the RGB Smart Bulb into the light socket. 3. Put your Z-Wave® controller into learning mode (refer to your controller's manual for instructions). 4.
. If exclusion is successful, the RGB Smart Bulb will blink orange rapidly for 5 seconds, then will illuminate steadily orange for 3 seconds. It will then remain on in the default color (warm white). ASSOCIATION The ASSOCIATION command class allows the RGB Smart Bulb to communicate with other Z-Wave devices directly, sending a BASIC REPORT whenever its status is changed. It supports 1 association grouping and up to 5 associated nodes. SELECTING A LIGHT COLOR 1.
ADVANCED CONFIGURATIONS This RGB Smart Bulb supports several advanced configuration settings. The following parameters can be accessed from your Z-Wave® controller's configuration interface. Status Memory Parameter #: 21 Default Setting: 0 Parameter Size: 1 byte The RGB Smart Bulb can be set to remember and restore its on/off status after a power outage. 0 = The RGB Smart Bulb remembers its on/off status when power is lost and will restore the on/off status when power is restored (default).
2 = The RGB Smart Bulb sends a BASIC REPORT only when the power load changes by some means other than by Z-Wave® command. Resetting to Factory Defaults Parameter #: 255 Default Setting: 1 Parameter Size: 4 bytes Resetting the RGB Smart Bulb will exclude it from the Z-Wave network. 1431655765 = Reset to factory default settings. SPECIFICATIONS Radio Protocol Z-Wave® Radio Frequency 908.
REGULATORY COMPLIANCE Radio Notice for FCC This FCC Part 15 radio device operates on a non-interference basis with other devices operating at this frequency. Any changes or modification to said product not expressly approved by Monoprice, including the use of non-approved antennas, could void the user’s authority to operate this device. This device complies with Part 15 of the FCC Rules.