User Manual

6
6. If exclusion is successful, the RGB Smart Bulb will blink orange rapidly for 5 seconds,
then will illuminate steadily orange for 3 seconds. It will then remain on in the
default color (warm white).
ASSOCIATION
The ASSOCIATION command class allows the RGB Smart Bulb to communicate with other
Z-Wave devices directly, sending a BASIC REPORT whenever its status is changed. It
supports 1 association grouping and up to 5 associated nodes.
SELECTING A LIGHT COLOR
1. Ensure that the wall switch is in the off position.
2. Screw the RGB Smart Bulb into the light socket.
3. Put the wall switch in the on position.
4. Toggle the wall switch off and on rapidly 2 times. This should be accomplished
within 2 seconds and should end with the switch in the on position. It will blink
purple rapidly for 1 second to indicate that it is in color change mode. It will then
cycle through Warm White, Cool White, Red, Green, Blue, and back to Warm White.
5. To set the color, wait until the desired color is showing, then rapidly toggle the wall
switch off and on within 1 second. The light will remain the color it was at when you
toggled the wall switch. Alternatively, put the wall switch in the off position for
more than 2 seconds to cancel the color change operation.
Alternatively, you can use the Android™ or iOS® app of an associated Z-Wave controller to
select any of the more than 16 million colors and to adjust the brightness.