User Manual

10
9. Touch the Back button on the Preheat Menu to return to the Main Menu, then
touch the Move button on the Main Menu to enter the Move Menu. Touch the
button in the Z column to raise the extruder about 3~5 cm above the build
platform.
10. While squeezing the lever on the Feed
Mechanism, insert the filament and push it into
opening. Keep pushing until you feel resistance as
it hits the hotend. This should be about 30cm of
filament. Release the lever on the Feed
Mechanism.
11. Touch the button in the E column on the
Move Menu to feed filament into the extruder/hotend. Continue touching the
button until several centimeters of filament have been extruded.
12. Using the included plastic scraper, clean the extruded filament from the nozzle and
build platform. It is normal for filament to ooze from the nozzle while the printer is
hot.
13. Touch the button on the Move Menu to return to the Main Menu.
14. Touch the Print button on the Main Menu. The printer will read the contents of the
memory card and display them on screen. Touch the cat.gcode file to start printing
the model. The sample print can take up to 3 hours to print.