User Manual

ASSISTED LEVELING

If the gap between the nozzle and the build platform is not correct, use the Auto Level

function to adjust the gap. You will want to perform Auto Leveling before using the printer

for the first time or after it is moved.

Note that the Auto Level function will determine the local offsets for each location on a

5"x5" grid. It will not set the global Z offset for the bed distance. This is set by tuning the

offset during the print or in the menu starting the auto level function. See the

GLOBAL Z

OFFSET LIVE LEVEL

section below for details.

1. With the printer powered on and the Main Menu displayed, touch the Move button

on the Main Menu, then touch the Tune button on the Move Menu to enter the Set

Offset Menu.

2. Touch the Auto Leveling button. The printer will move the extruder to different

points and measure the distance from the nozzle to the print bed to determine the

proper local offset at each point. This function only works with the metal print bed,

which is standard on the MP10 Mini printer.