User Manual

3. Touch the Move button on the Main Menu to enter the Move Menu, then touch the

button in the Z column to raise the extruder about 3~5 cm above the build

platform.

4. Using the plastic scraper, clean the extruded filament from the bed and hotend.

5. Touch the Tune button on the Move Menu to enter the Set Offset Menu. If the

nozzle was too close, touch the FAR button. If the nozzle was too far, touch the

CLOSE button. This adjusts the Z Offset by 0.1mm.

6. Once the gap is where you want it, touch the button to save the data and exit

the menu.

7. Restart the print by following steps 14-16 in the

SETUP

section above.

GLOBAL Z OFFSET LIVE LEVEL

While printing the model, you can use this function to fine tune the gap between the

nozzle and the bed. Touch the Tune button to enter the Bed Level Correction menu, then

touch the FAR or CLOSE to increase or decrease the gap between nozzle and the bed. This

can assist in getting a good first layer, but be careful to allow the printer a short period of

time to implement the change.