User Manual

M550 SSID

M551 PASSWORD

;

G1 X150 Y150 F1000 ; CENTER bed to signify completion

M106 S0 ; turn fan off to signify completion

M84 ; disable motors

Note that in the above gcode block, there are four lines that start with a semicolon. The 1st,

3rd, and 4th lines have a single space after the semicolon and the 2nd line has two spaces

after the semicolon. These spaces must be present, so do not use a text editor that strips

trailing spaces.

SOFTWARE INSTALLATION AND SETUP

As you've seen, you can print a model directly from a gcode file on a microSD

™

card and

this is the preferred method, as it does not require a continuous connection to your

computer. You can download gcode files to the microSD card and print them without

having to build any model files.

However, you can create your own gcode files using an open source program, such as Cura

or Repetier-Host, which are pre-installed on the microSD card that comes with the printer.

These programs use 3D models (typically .STL or .OBJ files) and, using machine specific

information, generate a gcode file with detailed instructions for the printer to create the

selected model. We recommend you start with Cura, since it includes a Slicing Engine.

Installing Cura

1. Use a card reader to read the contents on the included microSD

™

card. Locate and

double-click the Cura_3.3.1.exe file to start the setup program.