User Manual

8
Axis Lead Screw from the Left Y Axis Carriage Bar, then replace the plastic brackets
and tighten the screws to secure them in place.
3. Using the included 3mm hex wrench, loosen the screw in the top of the motor
coupling, so that the Z Axis Lead Screw can be inserted.
4. Insert the Z Axis Lead Screw through the hole in the top of the frame, then thread
the it through the hole on the extruder housing until the unthreaded portion of the
screw is fully inserted into the motor coupling. When it is properly inserted, the top
will be flush with the frame. Tighten the screw loosened in the previous step to
secure the Z Axis Lead Screw to the motor.
5. Using the 2.5mm hex wrench and 2x M4x6 screws, fix the LCD Display Module to
the the printer frame. Insert the plug into the back of the module.
6. Align the t-nuts in the frame with the holes on the filament holder, then using the
2.5mm hex wrench and 2x M4x6 screws, secure the filament holder to the frame.
7. Mount the extruder hotend to the bracket on the X Axis Gantry by aligning the
positioning rods and magnets. Ensure that the cables are on top.
8. Plug the three cable connectors into the appropriate connections on the front left
side of the Left Y Axis Carriage, beneath the Z Axis Lead Screw storage location
referenced in step 3 above.
SETUP
Warning! Take care not to remove or damage the printing surface on the build platform.
This paper is essential to ensure the 3D model properly adheres to the build platform
during printing. If this tape becomes damaged or wears out, replace it with painter's tape,
Kapton® tape, or ordinary masking tape.
Perform the following steps to prepare the printer for use.
1. Put the printer on a flat, stable surface with plenty of ventilation and a nearby AC
power outlet.
2. Ensure that the Power Switch is in the OFF position. Plug the included AC Power
Cord into the AC Power Connector jack on the right side of the printer, then plug