User Manual

9
the other end into a nearby AC power outlet. Flip the Power Switch to the ON
position.
3. Insert the included memory card into the slot on the right side of the LCD module.
4. Touch the Preheat button on the Main Menu.
5. Touch the Nozzle button, then set the temperature of the nozzle to your target
value. The target value depends on the type of filament being used. For the
included sample PLA filament, the temperature should be between 200~220°C.
6. Touch the Bed button, then the temperature to the target temperature for your
filament type.
7. Touch the Start Preheat button. The printer will start preheating the nozzle and
heated print bed to your target value(s) and the Start Preheat button will change to
Stop Preheat. The Nozzle and Bed buttons will display the temperatures as they
change.
8. While the printer is heating, open your filament. Using a pair of scissors or side
cutters, diagonally snip the end of the filament to make a point, as shown in the
images below. Place the filament reel on the filament rack.