Manualshelf

User Manual

ManualsBrandsMonoprice Manuals3D Printers140108 MP Cadet 3D Printer, Full Auto Leveling, Print Via WiFi, Small Footprint Perfect for a Desktop, Office, Dorm Room, or The Classroom
31323334353637383940
37
When the camera is turned on or off, the local computer will disconnect and then
reconnect to PolarCloud, so it will not respond for a while. The recovery speed
depends on the state of the network.
After the camera is operated through the Cloud, the local computer will set the
camera to operate in Manual Mode. To return to Auto Mode, use the OSD menu to
enable Auto Mode.
Error Handling
If the camera is damaged or otherwise inoperable, the camera screen will display the error
message shown in the image below and to the left. At this point, the local computer will
automatically set the camera to Manual Mode and will turn it off. Touch Confirm to clear
the error message.
If the local computer does not connect to PolarCloud and the printer is deleted from the
Cloud, the camera screen will display the error message shown in the image above and to
the right. Touch Confirm to clear the error message. To fix the error, restore the factory
default settings. After the local computer connects to the printer and the printer is deleted
from the Cloud, you will need to sign up for PolarCloud again.