User's Manual

• After 30 minutes of no audio signal input, the speakers will

automatically enter standby mode. The LED on the Primary Speaker

Front Panel corresponding to the last used input will blink slowly.

The last set volume level and input will be restored when the

speakers are powered back on.

• Place the POWER switch on the Primary Speaker Rear Panel in the

OFF position to turn the speakers fully off, without going into

standby mode.

BLUETOOTH PAIRING

Perform the following steps to pair your mobile device with the speakers.

1. Flip the POWER switch on the Primary Speaker Rear Panel to the

ON position.

2. Momentarily press the Volume knob on the Primary Speaker Front

Panel to turn the speakers on. Alternatively, press the

ON/STANDBY button on the included Remote Control. One of the

source LEDs will illuminate to indicate the last input used.

3. Repeatedly press the Volume knob on the Primary Speaker Front

Panel to cycle through the inputs until the BT LED starts blinking

slowly, indicating that the speakers are in Bluetooth® pairing mode.

Alternatively, repeatedly press the PAIR button on the included

Remote Control to put the speakers are in Bluetooth® pairing

mode.

4. Open the Bluetooth settings on your mobile device and scan for

nearby Bluetooth devices.