MM-5&MM-5R Powered Multimedia Speakers with Bluetooth® P/N 38619/38620 User’s Manual
FEATURES ·5.25" paper cone woofer ·1.5" silk dome tweeter(38619);2.6’’ AMT tweeter(38620) ·42Hz~20KHz frequency response(38619);42Hz~22KHz frequency response(38620) ·Dual class AB amplifiers with 2x 60 watts to the woofers and 2x 30 watts to the tweeters ·Bluetooth® version 5.0 radio with the Qualcomm® aptXTMHD audio codec ·Subwoofer and 3.5mm headphone outputs ·Stereo analog RCA,stereo analog 3.
PRODUCT OVERVIEW Front Panel 1. 1.5" silk dome tweeter(38619);2.6’’AMT tweeter(38620) 2. 5.25" paper cone woofer 3. 3.
4. Wooden isolation/elevation stands 5. AUX LED indicator 6. RCA LED indicator 7. Bluetooth LED indicator 8. Optical LED indicator 9. USB LED indicator 10. Volume knob Rear Panel Master Speaker 1. Digital optical input jack 2. USB input jack 3. On/standby On/standby switch 4. 3.5mm TRS input jack 5. Stereo RCA input jack 6. Subwoofer output jack 7. USB charging output jack USB charging port 8. Speaker output connector 9. Power switch 10. AC input jack AC power inlet Slave Speaker 11.
INSTALLATION 1.Ensure that the Power Switch on the rear panel of the Master Speaker is in the OFF position. 2.Plug one end of the included Speaker Connection Cable into the Speaker Input Connector on the rear panel of the Slave Speaker, then plug the other end into the Speaker Output Connector on the rear panel of the Master Speaker. 3.(Optional) Using a 3.5mm stereo audio cable, plug one end into the 3.
BLUETOOTH PAIRING Perform the following steps to pair your mobile device with the speakers. 1. Flip the Power Switch on the rear panel of the Master Speaker to the ON position. The LED Indicator on the front panel will illuminate. 2. Select BT by short pushing the volume knob (SOURCE on IR remote) until reaching the BT position (this will be visible through a slowly blinking white LED). 3. Open the Bluetooth settings on your mobile device, then scan for nearby Bluetooth devices. 4.
OPERATION Note that the output of the speakers is the sum of all inputs. Unless you specifically want to listen to a mix of different sources, only one audio input should be in active use at a time. 1. Rotate the Volume Knob on the Master Speaker fully counterclockwise. 2. Press the Power Switch on the Master Speaker to the ON position. The LED Indicator on the front panel will illuminate. 3. Start audio playback on your audio source device. 4.
