User's Manual

44
• Raft Top Line Width (mm): This is the width of the lines in the top surface of the raft.
These lines can be thin, so that the top of the raft is smooth.
• Raft Middle Line Width (mm): This is the width of the lines in the middle raft layers.
Making the second layer extrude more causes the lines to stick to the build plate.
• Raft Base Line Width (mm): This is the width of the raft base layer. These should be
thick lines to assist with build plate adhesion.
• Prime Tower Line Width (mm): This is the extrusion width of the prime tower.
Warping Protection Tab
• Z Offset (mm): When the Z axis bias is set to a negative value, the nozzle will print
closer to the build platform, which helps reduce warping on large models.
• Extra Skin Wall Count: This value sets the number of contours on the outer surface
of the model.
• Initial layer Increment (°C): This value is used to increase the printing temperature of
the first layer, which helps reduce warping on large models.
Seam Tab
Note: The Z Seam is where the printer finishes its motion when printing the skin (outside
layer) of a model. This can result in a small blob where the printer changes the Z height. If
in alignment, there can be a noticeable line up the side of the print, referred to as a Z