Use and Care Manual

855-833-6483 OR EMAIL US AT [e-mail]855-833-6483 OR EMAIL US AT [e-mail]
9
Operating Controls
Rear Brake Lever
The brake lever is used to apply the brake to the rear wheel
and will slow or stop the mini bike. When you pull back on
the lever, the brake cable pulls a lever on the brake caliper
causing the caliper to close on the brake disc. The amount
of force that you use when pulling the brake lever will de-
termine how much braking power is applied. To release the
rear brake, release the brake lever.
Pull Starter Cord
Air Filter
The air filter is used to keep dirt and large objects out
of the engine’s air supply. It is located at the rear of the
engine under the air filter cover. Examine the filter before
each ride to be sure it is not dirty and/or full of debris. You may
also use air filter oil (usually in spray cans) to keep the filter
flowing properly.
The Pull Starter Cord is used to start the engine and has a
recoil mechanism to retract the cord after the engine has
been started. It is located on the right side of the mini-bike,
directly below the front of the seat.
Spark Plug
The spark plug is used to produce the spark that fires the
engine. You should never touch the spark plug when the
engine is running or you will be shocked. Please refer to the
Basic Maintenance Procedures section of this manual for
detailed instructions on cleaning and replacing a spark
plug.
855-833-6483 OR EMAIL US AT [e-mail]