Use and Care Manual

855-833-6483 OR EMAIL US AT [e-mail]855-833-6483 OR EMAIL US AT [e-mail]
21
Basic Maintenance Procedures
1. Park the mini bike on a firm level surface.
2. Remove the oil fill cap/dipstick.
3. Place an oil drain pan under the engine.
4. Unscrew and remove the oil drain bolt.
5. Once most of the oil has drained, move the mini bike
from side to side to drain out any remaining oil.
6. Examine the sealing washer for damage and replace
if any damage is present.
7. Install the oil drain bolt and tighten to the specified
torque of 18 foot pounds.
8. Pour the recommended oil into the engine and fill
until the oil level is correct.
9. Install the oil filler cap/dipstick and tighten securely.
10. Start the engine and let it run for a minute or two.
11. Shut off the engine and check the engine oil level,
add oil if needed. Do not overfill.
12. Check for any oil leaks.
13. Dispose of waste oil in an approved manner.
Changing Engine Oil
Air Filter
Your air filter is located on the back of the engine in the square plastic case. Proper air filter
maintenance is extremely important for off-road vehicles. Dirty, water-soaked, worn out, or defective
air filters will allow dirt, dust, mud and other impurities to pass into the engine. Always replace the air
filter with a filter of the same size and construction.
NOTICE
Always dispose of waste
oil in the proper manner.
Failure to do so is harmful
to the environment and
illegal in most states.
1. Unclip the clips holding the air cleaner cover to
the housing
2. Remove the air filter
3. Wearing rubber gloves and eye protection, clean
filter with a non-flammable solvent like mineral
spirits. Squeeze excess solvent from media, taking
care to not damage filter element
4. Inspect foam for cracks or tears and replace if
needed
5. Allow filter to dry completely
6. Soak filter in a quality air filter oil and squeeze out
excess oil
7. Reinstall element and replace cover