Use and Care Manual

855-833-6483 OR EMAIL US AT [e-mail]
PROBLEMS? DO NOT RETURN TO STORE! CALL US!
8
Operating Controls
Engine Stop
The engine stop switch is used to turn off the engine.
When the switch is in the “OFF” position, it will remove the
spark from the ignition system. To start and ride the go-
kart, push the small red button (top). This is the “RUN”
position. To shut off the engine, push the large red button
(bottom). This is the “OFF” position.
Attaching the Roll Bar, Flag & Front Bumper
To attach the roll bar, follow the steps below:
1. Attach the plastic mounting caps on the ends of both bars.
2. Use provided allen screws to attach roll bar to brace.
3. Attach roll bar assembly to the frame using the provided allen
screws.
4. Attach the two crash pads to the roll bar, above the seat.
To attach the safety ag, follow the steps below:
1. Assemble flag pole by inserting the two pole pieces into
each other. Draw flag pole through safety flag.
2. Loosen the four screws on the flag mount.
3. Insert flag pole (with flag attached at top) into the flag
mount.
4. Tighten the four screws on the flag mount.
To attach the front bumper, follow the steps below:
1. Attach bumper onto brackets located on the front of the
frame.
2. Use provided bolts and nuts to attach the bumper.