Instruction manual

During installation, you should protect the tower by doing all the layout of the tower on a

tarp, blanket or carpet and leave as much of the bubble wrap sleeves on the legs and

top section as possible. Use masking tape to protect your deck from scratches as you

determine the final location of the bases. Apply included Anti-Seize to all bolt threads to

prevent galling and locking of the precision stainless steel hardware.

The first step when installing the tower is to understand where you want the tower to fold

down to in your boat. This will determine where the rear bases will attach to the boat. If

your tower is going to be folded down, this is more important than where the tow point is

located. You will want the top section of the tower to rest on your floor, rear seat or sun

pad when folded down. To ensure the tower lays down the way you want, you need to

lay it out before installing the bases.

To begin the layout process, attach the rear legs (part 5) to the top section (part 13) with

hardware Item 16

WITH ANTI-SEIZE on the outside of the threads to attach the rear legs

as shown below. The blue dot on one rear leg mates with the blue dot on the top section.

The rear legs should radius towards the outside and front of the boat as shown in this

manual. Tighten the setscrews in the top section to hold the top section at about 30

degrees from vertical. Do Not Loosen these set screws when folding the tower.

NOTE – If

you plan to purchase the Monster Tower Bimini, it mounts to the rear legs of the tower. If the tower is

mounted too far back, the driver will not be covered by shade.

Before moving the rear legs and top section to the boat, pre-assemble the leg ends as shown:

1) Confirm Heim joints (part 7) are screwed into the end of each leg as far as possible as shown above

to the right.

2) Attach the Heim joint to the Base Assembly as shown in the Base Assembly view.

Make sure the o-

ring is on the bolt between the Heim joint and Base Swivel. (The o-ring aligns the Heim joint to the

base swivel and is not required after installation).

Now prepare your boat by putting masking tape on the hull in the locations you will

mount the rear bases. You can also put towels or tarps on your deck as well for added

protection. Try different mounting locations to confirm you like the tower location in the

folded position. Customer photos at our website can be a big help also for where to

mount the tower.