User Manual

Monster Cable Products Inc.
Universal FM Transmitter User guide
Preliminary Draft
Setup Instructions:
This product is fitted with a stereo headphone plug. It is designed to connect to the "Headphones" output
of audio playback devices such as portable MP3 players, CD players, and stereo tape recorders.
1. Plug the Monster Universal FM transmitter to the headphones jack of your portable audio device.
2. Plug the Monster Universal FM transmitter to your automobile 12v cigarette lighter outlet.
3. Set the Monster Universal FM transmitter to desired FM channel by pressing the push-button switch and
noting the channel indication.
4. Tune your automobile FM stereo to same channel as indicated by Monster Universal FM transmitter.
5. Set audio device to playback and adjust its volume control to same setting you normally use when
listening with your headphones.
6. Adjust automobile FM stereo volume control to desired level.
For best results, preset the Monster Universal FM transmitter to FM channels that are not occupied by
strong local FM broadcast stations.
Additional information is available at www.monstercable.com.
Warranty does not include malfunction caused by accident, misuse, contact with solvent chemicals or
malfunction caused by tampering or modification. This warranty excludes all incidental or consequential
damages. Some states do not allow the exclusion or limitation of consequential damages so the above
limitation may not apply to you.
For Warranty Service, the product must be returned at your expense to place of purchase. Return
policies may vary. If you cannot reasonably do this, please contact us stating the nature of the defect and
date of purchase. Include a copy of your sales slip or proof of purchase. Your repaired or replacement
equipment will be returned to you at our expense. This warranty gives you specific rights: you may also
have other legal rights which vary from state to state.
FCC Notice: This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. Caution: changes or
modifications not expressly approved by Monster Cable Products Inc. may void the users authority to
operate this device.
Note: This equipment has been tested and found to comply with the limits for a class B digital device
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
 Reorient or relocate the receiving antenna
 Increase the separation between the equipment and receiver
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
 Consult the dealer or an experienced radio/TV technician for help.
Monster Cable Products, Inc.
455 Valley Drive Brisbane, CA 94005
Phone [phone]
FCC ID : RJE160836-00