User's Manual

iCarPlay
™
Wireless 200
Car Stereo FM Transmitter/Charger
iCarPlay
™
Wireless 200 Features
• High-quality stereo audio
• Full range of FM stations, from 88.1
to 107.9 (U.S. mode)
• 3 “favorite station” programmable presets
• iPod
®
screen display of FM frequency
®
screen display of FM frequency
®
• AutoScan automatically fi nds best FM frequency
• 30-ft. maximum range**
• Micro-processor controlled
• Built-in antenna
• Powered by 12V car cigarette lighter adapter
• International FM tuning for U.S., Europe,
and Japan
• Auto-reset fuse to protect unit and iPod
• Charges iPod while in use
INSTRUCTIONS
Connecting to the iPod
1. Plug the iCarPlay Wireless 200 power adapter
into your car’s 12V accessory outlet (cigarette
lighter socket) and turn your iPod on.
2. Plug the iCarPlay Wireless 200 dock unit into
your iPod docking connector. The iPod screen
will fl ash the check symbol and the words
“OK to disconnect,” and then iPod will revert
back to the regular iPod menu.
Selecting the 3 FM Station
Memory Presets
iCarPlay Wireless 200
features 3 FM Station Memory
Presets to make it easy for you to quickly select
commonly used channels that you can set (see next
section). You may fi nd, for example, that one frequency
works best in one part of town and another works
better elsewhere.
1. Press the “S” button twice. (This will stop music
playback on the iPod.)
2. Press Right or Left button to select the desired
preset frequency.
3. Press the “S” button to select.
4. Tune your FM radio to the same channel
as indicated on the iPod display screen.
AutoScan FM Frequency Selection
(recommended)
The iCarPlay Wireless 200 features AutoScan
to automatically fi nd the best, clearest FM channel
in your local area. The process takes about a minute.
Remember that as you drive through different areas
the FM signal conditions change, so when driving
long distances, you can repeat the AutoScan selection
whenever FM interference occurs.
1. Press TWICE on the “S” button. (This will also stop
music playback on the iPod.)
2. Press the Right or Left button to highlight AutoScan.
3. Press and hold the “S” button for two seconds.
4. AutoScan will begin searching through the entire
FM range to fi nd the best frequency. This may take
up to 1 minute. Then iCarPlay Wireless 200 will
automatically select the best frequency and display
it on the iPod screen. NOTE: After a few seconds
the iPod will return to its regular menu, so it’s
important to note the AutoScan selected frequency
while it’s shown.
6. Tune your FM radio to the same channel.
Manual FM Frequency Selection
1. Press the iCarPlay Wireless 200 “S” button
once. (This will stop music playback
on the iPod.)
2. Press Right or Left button to select
FM frequency.
3. Press the “S” button again. The iPod will return
to its regular menu.
4. Tune your FM radio to the same channel.
Setting Memory Presets
You can program the 3 FM Station Memory Presets
to any frequencies in the FM range. iCarPlay Wireless
200 will continue to remember these presets even
when both power and the iPod are disconnected,
so they’ll always be ready to use the next time
you need them.
1. Press the “S” button twice. (This will stop music
playback on the iPod.)
2. Press the Right or Left button to highlight the FM
Station Memory Preset that you’d like to change.
3. Press and hold the “S” button for two seconds
to enter Preset tuning.
4. Press Right or Left to scroll tune the desired FM
frequency displayed on the iPod screen.
5. Press the “S” button again. The FM Station Memory
Preset will be set, selected, and the iPod will return
to its regular menu.
International FM Tuning Selection
iCarPlay Wireless 200 works with FM radio systems
worldwide. To select a different tuning system:
1. Press the “S” button THREE TIMES. (This will
stop music playback on the iPod.)
2. Press the Right or Left to select the desired
International Mode.
US: 88.1 - 107.9 MHz (with 0.2 intervals)
Europe: 87.8 - 108.1 MHz, (with 0.1 intervals)
Japan: 76 - 90 MHz (with 0.1 intervals)
4. Press the “S” button again. The International
Mode will be set, and the iPod will return
to its regular menu.
•
•
•
User Guide & Warranty Information
**Range determined by product specifi cations and other environmental variables
5. Press the ‘Play’ button on your iPod.
6. Use your car radio’s volume knob to adjust
sound level.
Note: iPod Backlight Timer Setting
Depending on your settings, your iPod’s screen
light may go out before you’re fi nished making
adjustments to the iCarPlay Wireless 200.
To ensure uninterrupted iPod screen viewing
during setup and FM frequency selection,
please set the backlight timer properties
on the iPod settings menu.
The words “OK to disconnect” will always appear
when in FM Transmitter mode, this is normal.
When selecting your FM station, in all instances,
the music will stop transmitting.
•
•
•
iPod
OK to disconnect.
Press S to Confirm
89
.1

iPod
OK to disconnect.
Tap S to Select Hold S to Set
89.1
  
