Iii MCINSTER® POWER SHIEL □ XL MRGNETIC SURGE PROTECTOR e ie IXl~ - co ,....--.... ...___.., ...
Attaching the Metal Plate STEPl. CLEAN WALL WITH RUBBING ALCOHOL. DO NOT USE HOUSEHOLD CLEANERS. STEP2. AFTER THE WALL IS CLEAN AND DRY, REMOVE LINING FROM 3M™ STICKER AND PRESS METAL FIRMLY FOR 30 SECONDS. (*WARNING: ADHESIVE MAY BECOME PERMANENT OVER TIME) CAUTION DO NOT HANG OVER BEDS OR ON WALLPAPER.
FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1} This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a wireless power charger, pursuant to Part 15 of the FCC Rules.
CAUTION DANGER: ELECTRICAL CORDS CAN BE HAZARDOUS Misuse Can Result In FIRE or DEATH by ELECTRICAL SHOCK Please Read Carefully and FOLLOW ALL Directions DURING USE ' • DO NOT USE WHEN WET. • DO NOT MOUNT OR SUPPORT CORD SET OR STRINGS IN A MANNER THAT CAN CUT OR DAMAGE WIRE INSULATION. • KEEP CHILDREN AND PETS AWAY FROM CORD. • DO NOT PLUG ONE EXTENSION CORD INTO ANOTHER. • AVOID OVERHEATING. • DO NOT DRIVE, DRAG OR PLACE OBJECTS OVER CORDS.
SURGE PROTECTOR INSTRUCTIONS 1. Set the power switch to the "OFF" position. Plug the surge protector Into a standard grounding wall receptacle by fully Inserting the plug and ensure that there are no exposed conductors. 2. Make sure electronic equipment Is turned off before plugging into the surge protector outlets. Do not use extension cords to connect equipment to the surge protector. 3. Set the power switch to the "ON" position. The surge protector will now be providing power and surge protection. 4.
equipment through the coax, phone or network lines. Lifeworks Technology Group, LLC will pay up to the maximum warranty amount offered for the surge protector purchased to repair or replace up to an amount equal to the fair market value or the original purchase price, whichever Is less, of your electronics equipment, if damaged by a transient surge (except those caused by direct lightning), within the life* of the surge protector, while properly and directly connected to this surge protector.
E) All connected equipment must be safety certified by a Nationally Recognized Testing Laboratory. F) The Installation must comply with all applicable electrical and safety codes set forth pursuant to the National Electrical Code (NEC). G) Not valid If Improperly Installed, tampered with, If used extension cords, if used 3 prong adapter, daisy chained, other surge protectors Involved, etc. 4.
PRODUCT SPECIFICATIONS AC 125VAC 15A 60Hz 1875W USB 125VAC 60Hz 0.8A Max USB-A: 5V 2.
