Instruction Manual

耳机开机后未连接蓝牙设备状态下，任意一个耳机三击左/右耳机MFB键，断开耳机与蓝牙
设备配对并关机
MODE XKT17
MODE XKT17
MODE XKT17
17
17
MODE XKT17
XKT17
When the headset is not connected to the Bluetooth device after startup, press the
left/right headset MFB button three times on any headset to disconnect the headset
from the Bluetooth device and shut it down
FCC 声明
该设备经过测试，符合B类数字设备的限制，根据FCC规则第15部分。这些限制旨在提供合理的限制住
宅装置中防止有害干扰的防护。该设备产生使用并能辐射射频能量，如不按规定安装和使用该指示可能
对无线电通信造成有害干扰。然而, 有不能保证在特定的安装中不会发生干扰。如果这个设备对收音机
或电视接收造成有害干扰，可通过转动判定设备的开关，鼓励用户尝试纠正干扰之一
或更多以下措施:
--重新定位或重新安置接收天线。
-增加设备与接收器之间的距离。
--将设备连接到与接收器不同的电路上的插座上连接。
-向经销商或有经验的无线电/电视技术人员寻求帮助。
该设备符合FCC规则第15部分。操作遵循以下两点
条件:
(1)本装置不得引起有害干扰，(2)本装置必须接受任何干扰
接收到的干扰，包括可能导致不希望的操作的干扰。
未得到合规方明确批准的变更或修改
可能使用户对设备的操作权限失效。
FCC ID：2A8PV-QSMXKT17
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
FCC ID：2A8PV-QSMXKT17