User Manual

Monster DNA ONE
Speaker Function Operation
This Bluetooth device shall be charged by the supplied charging unit only.
Caution: The batteries in this product are not replaceable. During use, storage or transportation
the battery should not be subjected to extremely low temperatures, or low air pressure at high
altitude. If the battery is exposed to extremely high temperatures it could result in an explosion or
the leaking of flammable liquid or gas. Please take care when disposing of the unit; disposal in a
fire, oven, mechanically crushing or cutting machine could cause an explosion.
Warning: Do not dispose of the unit in fire or water. Never attempt to disassemble and reassemble.
Waste electrical products should not be disposed of with household waste, please recycle where
facilities exist. Check with your local authority for recycling advice. Keep your device and all
accessories out of the reach of children and animals. Small parts may cause choking or serious
injury if swallowed. Avoid exposing your device to very cold or very hot temperatures (Below 0° or
above 45° C). Extreme temperatures can cause deforming of the device and reduce the charging
capacity and life of your device. Do not allow your device to get wet, liquids can cause serious
damage. Do not handle your device with wet hands.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth® SIG, Inc.,
iPhone, iPad and Mac is a trademark of Apple Inc., registered in the U.S. and other countries.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a wireless power
charger, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the product.
Made in China - Model: 2MNBD1115
Product Specs:
IP67-Rating: waterproof speaker, dust-proof, floats in water
IP67-Rated speaker, speaker can float
Bluetooth Range - 30ft
Music sharing from speaker to multiple speakers – hardware button
(no app required)
USB Type-C
TM
Charging port
QI Wireless charging receiving coil
Battery Life: Up to 13 hours
Charge time: 2.6 hours
With hands free function
Package Includes:
(1) Wireless Speaker, *(1) Qi Charger (not IP67),
*(1) USB Cable (not IP67), User Manual.
Warranty: 2 Year Limited Lifetime Warranty
See more at monsterforever.com
2022 © The M Monster logo, the M Slice and Pure Monster Sound are trademarks
or registered trademarks that are used under license of Monster, Inc.
2022 © All rights reserved. USB Type-A™, USB Type-C™ and USB-C™ are
trademarks of USB Implementers Forum. Manufactured, marketed and
distributed by Lifeworks Technology Group LLC. under license. New York, NY
10018. All other trademarks are property of their respective owners.
website: www.monsterforever.com support: [e-mail]
English
For French, Spanish and Portuguese
instructions scan here:
www.monsterforever.com
Wireless
Charging Base
LED Indicator
Volume-/
Previous Track
Button
Bluetooth
Pairing Button
USB Type-C™
Charging Port
Power Button
LED Ring
Volume+/
Next Track Button
Monster Share
™
Party Mode
Button
Power Button:
Press once:
answer call/end call/play/pause
Press and hold for 2s:
power on/o/call reject
Volume + / Next Track:
Press once:
volume up
Press and hold for 2s:
next track
Volume - / Previous Track:
Press once:
volume down
Press and hold for 2s:
previous track
Monster Share™, Party Mode:
Press and hold 2s to set
transmitting speaker
Press once to set receiving
speakers
Connect up to 99 Monster DNA
Speakers
Bluetooth Pairing Button:
Press and hold for 2s :
Bluetooth pairing
Charging Port(USB-C™)
Battery Level Indication
Press and hold “-” and “+” buttons
Function:
Pairing - First time:
1. Press and hold the Power button around 2s to turn on the speaker.
2. When turning the speaker on for the first time, it will automatically be
in pairing mode. The LED Ring will flash Blue in a clockwise motion.
3. Activate your Bluetooth device and search for “Monster DNA ONE”
speaker.
4. Once the speaker is connected successfully, the LED Ring lights up
blue for 3s, then turns o.
Pairing - Manually:
1. After power is on, the speaker will attempt to connect to the last
connected device.
2. To pair another device, press and hold the Bluetooth Pairing Button for
2s. The LED Ring will flash Blue in a clockwise motion.
3. Activate your Bluetooth device and search for “Monster DNA ONE”
speaker.
4. Short press Bluetooth Pairing button again to disconnect.
Bluetooth Mode:
1. Press once: Volume +/- button for volume up/down
2. Press and hold for 2s: Volume +/- button for next/previous track
3. Press once: Power button to start music play/pause
4. Press once: Power button to answer an incoming call or ending a call
5. Press and hold for 2s: Power button to reject an incoming call
USB/Wireless Charging:
1. To charge the speaker by USB-C, connect the included USB-C cable
and plug it into a USB power source (such as the USB-C wall adapter
provided). For wireless charging, connect the Wireless Charging Base
to the wall adaptor and place the speaker directly on it.
2. The LED Ring light will ‘breathe’ with a white glow while charging.
3. Once fully charged, the LED Ring will show a white light for 5s,
then turn o.
Charging Out:
1. Connect your device(such as a smartphone) to the speaker’s Charging
Port and charging will start automatically.
Monster Share™, Party Mode:
1. Turn on all Monster DNA speakers you would like to connect by
pressing and holding the Power button for 2s.
2. Connect to one of the Monster DNA speakers by Bluetooth, and press
and hold the ‘Monster Share™ Party Mode’ button for 2s to set this
as the main transmitting speaker. A flashing purple light will appear
indicating Party Mode transmission is in pairing mode.
3. Single press the ‘Monster Share™ Party Mode’ button on all other
speakers that you would like to set as receiving speakers. A green
light will flash in a circle while pairing and will turn solid Green
once paired.
4. If speakers are not paired within 30s, ‘Monster Share™ Party
Mode’ pairing will time out. Restart this process to connect
additional speakers.
5. Press the ‘Monster Share™ Party Mode’ button once again to exit
Party Mode.
*Monster Share™ Party Mode works with compatible Monster
Speakers enabled with Monster Share™ technology
Auto Power O:
The speaker will turn o automatically in 15 minutes if no connection was
found or idling.
REV012322
Monster DNA ONE Manual
- Matte Finish
- Place Manual inside the envelope
Envelope
- Matte Black 350 gsm cardstock front and back
- Spot UV
- Cardstock
Stickers
- Matte Finish
- Place Stickers Inside the Envelope
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.