Instruction Manual

Pair Another Phone
Multipoint technology enables you to pair another
phone and take a call from either.
To pair with another mobile phone, power off
the headphone, then follow the steps for “Pair
one phone”. After pairing successfully, restart the
headphone to connect to 2 paired mobile phone
automatically and manually.
Note: You may need to connect the second
phone manually.
Call
Answer a Call: Press the Multifunction button once.
Reject a Call: Press and hold the Multifunction
button for about 1 second.
End a Call: Press the Multifunction button once.
Redial the Last Call: Press Volume”+” and “-” for
about 3 seconds in standby mode. The mobile
phone will redial the last call number.
Mute On/O: Press the Volume “-” for about
3 seconds to mute on/off.
Switch Between the Headphone and Phone:
Press the Multifunction button for about 1 second
during a call, the call will be switched to the mobile
phone, redo this operation again, the call will be
switched to the headphone.
End Current Call and Answer New Call: When a
new call rings during a call, press the Multifunction
button once to answer new call and end current
call simultaneously.
On Hold Current Call and Answer New Call:
When a new call rings during a call, double press
the Multifunction button to hold current call and
answer new call. To switch between held call and
active call, double press the Multifunction button.
Activate Voice Dialing: Double press the
Multifunction button to trigger the voice dialer,
this function varies with user’s smartphone.
Music
Play / Pause Music: Press Multifunction button
once to play / pause music. (Some phones may
require you to start a media player first).
Track Back / Forward: Press the Volume “-” for
1 second once to skip track backward, press Volume
“+” for 1 second once to skip track forward.
Switch Music and Call: When a call rings during a
music playing, the music automatically pauses to
allow you to answer or ignore the call. Once the call
is ignored or ends, the music is resumed.
More Features
Battery Indicator
When the headphone is connected to a device with
iOS system, a battery indicator will appear at the
upper right of the system, indicating battery status
of the headphone.
Auto Power-O
When the distance between the headphone and
the mobile phone is beyond effective range, a
warning tone will be alerted and headphone will try
to reconnect with the mobile phone for 10 minutes.
If no phone is reconnected within 10 minutes, the
headphone will go to connectable mode and wait
for 5 more minutes before automatically power off.
Automatic Connection After
Powering On
When the headphone and phone have been
paired once, they will automatically connect when
the headphone is on and Bluetooth is activated
on the phone.
Connection Standby
After successful pairing and connection, you will
hear the voice prompt “Phone 1 connected”. The
headphone will be in turning on mode or standby
mode automatically and the blue LED will flash
once every 5 seconds. When the phone disconnects
the headphone, you will hear the disconnect tone.
Reset Paired Device(s)
Go to the Pairing mode (hold the Multifunction
button for 5 seconds from Power off state), then
hold the Volume “-” to reset the paired device(s),
indicator light flashes blue and red alternatively
and rapidly few times, you will also hear the tone.
Hardware Reset
Plug the Micro USB cable into the USB micro port
of headphone to connect it to the computer or
other device made for USB charging to have the
hardware reset.
Certication
FCC ID: RJE190653
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any
interference received, including interference
that may cause undesired operation. Changes or
modification not expressly approved by the party
responsible for Compliance could void the user’s
authority to operate the equipment. Connecting of
peripherals requires the use of grounded shielded
ENGLISH
ENGLISH