Instructions / Assembly
Assembly Instructions for Log Deck Bench & Deck Chair
Thank you very much for purchasing our heirloom quality log deck Bench/Deck Chair. Should you have
any questions or need to contact sales or support, please do not hesitate to contact our corporate offices
at 888.889.3728 or via E-Mail at: cs@montanawoodworks.com
Before beginning assembly please take a few moments to read the instructions carefully, understanding
each step. Likewise please also ensure that the hardware package contains the items as described here.
Tools Needed: 9/16” Wrench or Socket
Parts List: (1) Log Back, (1) Log Seat, (2) Log Arms,
Hardware List: (8) 3” Lag Bolts & Washers
Assembly Directions:
Step 1. Lay one arm on the floor, with holes facing upward.
Step 2. Insert seat tenons into the holes marked “A” & “B”.
Step 3. Insert back tenons into the holes marked “C” & “D”.
Step 4. Leaving sub assembly in the same position, place the opposite arm onto the seat and back tenons.
Tap with rubber mallet if needed.
Step 5. Carefully set bench into upright position.
Step 6. Insert lag screws with washers into the predrilled holes and TIGHTEN FULLY.
Your new deck bench is now fully assembled. Enjoy!
PROUDLY MADE IN THE U.S.A.
Please Note” If you purchased your glider “ready to finish” special care must be taken to properly apply
a high grade final finish in a timely manner. Doing so will help protect your purchase from discol-
oration and damage caused by exposure to ultra-violet light and/or weather. If the intended use is
outside, please use an exterior finish to also protect the item from weather damage. See use and
care instructions for further information. Failure to adequately protect item by the applications of a
final finish may void warranty. Failure to annually re-inspect final finish and re-apply as necessary
my void warranty