Instructions / Assembly

Assembly Instructions for Log Glider and Single Seat Log Glider
Thank you very much for purchasing your heirloom quality log glider from Montana Woodworks®.
Should you have any questions or need to contact sales or support, please do not hesitate to contact our
corporate offices at 888.889.3728 or via E-Mail at: [e-mail]
Tools Needed: 9/16” Wrench or Socket, Rubber Mallet
Before beginning assembly please take a few moments to read the instructions carefully, understanding
each step. Likewise, please also ensure that the hardware package contains the items as described here.
Parts List: (1) Log Back, (1) Log Seat, (1) Right and Left Arm, (1) Lower Glide Assembly
Hardware List: (8) 3” Lag Screws, (8) Washers, (4) 4” Hex Bolts, (4) Hex Lock Nuts, (8) Washers (4) Levelers
Assembly Directions:
Step 1. Remove components from boxes. You may lay the cardboard on floor to prevent marring of fin-
ish.
Step 2. Place arms “A” onto tenons of seat assembly “B” and back assembly “C”.
Step 3. Tap with rubber mallet if needed.
Step 4. Insert lag screws “F” with washers into the pre-drilled holes and TIGHTEN FULLY.
Step 5. Place completed seat/back assembly over lower glide assembly “D” making certain that the front
of glide assembly is forward.
Step 6. Insert one bolt through each hole in the four pre-attached glide swivels “E”.
Step 7. Place one washer on each bolt so there is a washer between the steel glide assembly and the log
surface. Step 8. Insert one bolt through each of the four predrilled holes in the lower glide assembly. Place
one washer on each bolt and hand tighten a nut onto each bolt.
Step 7. Gently glide unit back and forth by hand. Do not sit on the assembly at this time.
Step 8. Using socket and wrench(s), TIGHTEN FULLY.
Step 8. Insert a leveler into each of the four, pre-installed receptacles on the bottom logs of the lower glide
assembly. Adjust each in turn until the glider is level.
Your new log glider is now fully assembled. Enjoy!
PROUDLY MADE IN MONTANA!
Please Note” If you purchased your glider “ready to finish” special care must be taken to properly apply a high grade final
finish in a timely manner. Doing so will help protect your purchase from discoloration and damage caused by exposure
to ultra-violet light and/or weather. If the intended use is outside, please use an exterior finish to also protect the item
from weather damage. See use and care instructions for further information. Failure to adequately protect item by the
applications of a final finish may void warranty. Failure to annually re-inspect final finish and re-apply as necessary my
void warranty.