SDS

Page 7/15
Safety Data Sheet
acc. to OSHA HCS
Printing date 12/11/2019 Reviewed on 12/11/2019
Trade name: MONTANA GOLD COLORS
(Contd. of page 6)
50.0.2
REL Short-term value: 1225 mg/m³, 500 ppm
Long-term value: 980 mg/m³, 400 ppm
TLV Short-term value: 984 mg/m³, 400 ppm
Long-term value: 492 mg/m³, 200 ppm
BEI
·
Ingredients with biological limit values:
67-64-1 acetone
BEI 50 mg/L
Medium: urine
Time: end of shift
Parameter: Acetone (nonspecific)
1330-20-7 xylene
BEI 1.5 g/g creatinine
Medium: urine
Time: end of shift
Parameter: Methylhippuric acids
67-63-0 propan-2-ol
BEI 40 mg/L
Medium: urine
Time: end of shift at end of workweek
Parameter: Acetone (background, nonspecific)
·
Additional information:
The lists that were valid during the creation were used as basis.
·
Exposure controls
·
Personal protective equipment:
·
General protective and hygienic measures:
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Do not inhale gases / fumes / aerosols.
Avoid contact with the eyes and skin.
Avoid contact with the eyes.
·
Breathing equipment:
Not necessary if room is well-ventilated.
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure
use respiratory protective device that is independent of circulating air.
·
Protection of hands:
In case of contact with spray dust protective gloves made of butyl shoud be used (min. 0.4 mm thick), e.g.
KCL Camatril, article no. 898 or similar products
Solvent resistant gloves
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/
the chemical mixture.
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
·
Material of gloves
Butyl rubber, BR
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the
application.
(Contd. on page 8)
USA