User Manual

V10A | Owner’s manual
9
The trademark Neutrik
®
Combo
®
is property of Neutrik
®
Control and connection panel
[1] Balanced input line 0 dBu / 20 kΩ, fitted with a Neutrik Combo
®
connector which accepts both XLR and jack plugs.
❯❯❯ See page 13.
[2] Balanced input Micro -40 dBu / 2 kΩ, featuring XLR plug.
[3] Balanced output line Link/Mixed fitted with XLR connector.
It allows parallel connection of two or more systems.
❯❯❯ See page 13.
[4] Red status LED indicator of thermal warning protection.
[5] Red status LED indicator of clipping.
[6] Green status LED indicator of signal.
[7] Green status LED indicator of ON-status.
[8] Line input volume, for level control of the signal on connector [1].
[9] Micro input volume. for level control of the signal on connector [2].
[10] BassBoost switch. When pressed it emphasizes the bass frequencies
to enhance the performances at low volume levels.
[11] HiPass switch. When pressed it cuts the bass frequencies for use with
subwoofer or as stage monitor.
[12] Link/Mixed switch. When pressed the connectors [1] and [3] are linked
in parallel to connect others systems. When de-pressed the mix of
Line & Micro signals is available on connector [3].
[13] POWER /0 - I: Mains power ON/OFF switch.
[14] Mains power cord socket (with built-in fuse). Use only the factory
supplied mains cable or a suitable cable with a ground connection
and marked with the safety approvals valid in the country of use.
When installing make sure that it is easy to get to this connector
and to the mains plug.
[12]
[3]
[2]
[9]
[10]
[4]
[5]
[6]
[7]
[8]
[1]
[13] [14]
[11]