Installation Guide

5
© 2013 Monte Carlo Fan Company
10/1/2013
13 14 15
16 17
18
Loosen one and remove one
preassembled screw from mounting
bracket. Save screw.
Install blade bracket with blade by 3
blade screws and washers provided.
Tighten securely. Repeat this process for
remaining blades.
Note: Make sure the side with a mark
“This side up” is installed upward.
Install the blade assembly to motor using
the preinstalled screws. Partially tighten
the set screws. Repeat this process for
remaining blade assemblies.
Tighten all set screws securely after all
the blade assemblies are installed to
motor.
Loosen 2 and remove 1 preassembled
set screws from the plate on motor. Save
screw for later use.
Connect the plug from fan to the plug
from LED light fixture. Make sure the
plugs are connected securely.
Attach the LED light fixture onto the plate
on motor, aligning its keyhole slots with
the preassembled set screws on the
plate and twist clockwise till lock.
Reinstall the screw removed in step 17.
Tighten all screws securely.
Lift canopy up, aligning its keyhole slot
with the preassembled screw on
mounting bracket and twist
counterclockwise to lock in place.
Reinstall the screw removed in step 13
and tighten all screws securely.
Install canopy cover onto canopy by
aligning its notches with the screws on
mounting bracket and twist clockwise till
tight.
17
13
Mounting bracket
Canopy
Screws
Canopy
cover
Blade
Blade bracket
Blade assembly