Owner’s Guide and Installation Manual 4ICR52XXD Series Fan UL Model No. : AC-552 Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: MODEL NUMBER: RETAILER ADDRESS: To register your fixture, please visit our website www.montecarlofans.com 9.13 kgs 20.
Cautions and Warnings WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVETHE FOLLOWING READ AND SAVE THESE INSTRUCTIONS Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70-1999), including fire-rated construction. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer.
1 Before you begin installing the fan, Switch power off at Service panel and lock service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. 4 Loosen 2 screws on yoke to allow down rod to slip into yoke. 7 Place yoke cover over downrod as shown.
10 11 12 Install keeper pin. Evenly tighten the 2 set screws on the yoke, once the down rod is in place. Make sure the studs protruding from the bottom of the Mounting bracket are installed with threads all the way through the bracket. 13 14 Safety cable installation 15 Remote transmitter dip switch Safety cable Lag screw Lag screw Safety cable Hang assembled fan from the mounting bracket installed to ceiling in previous step. Make sure the fan is hanging straight.
20 19 Enhance plate Lift Conopy allowing the 2 studs to protrude through the canopy. Install knurled nuts and tighten the knurled nuts securely. The canopy should adjust for any irregularity in the ceiling or outlet box. Insert blade into the slot on flywheel and install blade screws, fiber washers and enhance plate aligning each of the holes as shown. Repeat this process for remaining blades. Note: The ABS blades are curved by design. Do not attempt to bend the blades.
26 27 Attach 2 GU24 13W CFL bulb and secure by twisting clockwise. Bulb included. WARNING: USE MAXIMUM GU24 13 WATTS LISTED SBCFL(SELF-BALLASTED COMPACT FLUORESCENT LAMP) ONLY, NOT USING SBCFL WILL OVERHEAT THE UNIT AND CAUSE DAMAGE TO THE UNIT OR THE FAN WHICH THE UNIT IS INSTALLED TOGETHER. Attach glass to light pan by locating dimples in light pan with grooves in glass and twist clockwise until tight. 29 30 HAND HELD INSTALL Place face plate over battery compartment and buttons.
Remote Control Transmitter Features: MEDIUM SPEED LED LIGHT FAN REVERSE (Press once to change direction of the fan) Fan must be running to reverse. LOW SPEED HIGH SPEED LIGHT ON/OFF SETTING (Press to turn on/off light) FA N O F F S E TT I N G (Turns fan off only) FAN SPEED Depress “1 dot” for low speed, “2 dots” for medium or “3 dots” for high. To turn fan off press square”. LIGHT ON/OFF To turn light on, press light button once quickly. To turn off press once quickly while light is on.
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet.
Mar.