Owner’s Manual Ceiling Fan Installation Instructions Total fan weigh with light For 5CLR66XXD Series Fans READ AND SAVE THESE INSTRUCTIONS Quality Ceiling fans
Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 701999), including fire-rated construction. Use this unit only in the manner intended by the manufacurer. If you have any questions contact the manufacturer.
7 8 9 Lift mounting neck to mounting Plate and align screws. Secure mounting neck to the mounting plate with four screws to become a complete mounting bracket. Remove keeper from cross pin and then cross pin from yoke. Replace keeper on cross pin and save. 10 11 12 Loosen lock nuts and screws on yoke till you can not feel screw on inside of yoke. Loosen set screw that holds ball. Slide ball down and remove pin save pin for later. 13 14 15 Thread leadwires and safety cable through downrod.
19 20 21 Install canopy onto downrod. Thread leadwires and safety cable through ball. Place ball on downrod. Replace pin removed earlier and pull ball up so that the pin fits in the notches in the ball. 22 23 24 Remote Transmitter Dip swtiches Remote Receiver Dip switches Tighten set screw to hold ball in place. 25 Tighten set screw to hold ball in place. 26 Safety cable installation Set dip switches on the Remote Transmitter and Remote Receiver to the same settings.
31 Align the blade and then the blade plate with castings on motor to attach blades to motor. 32 33 Loosen 2 screws and remove 1 screw. Save screw removed. 36 34 35 Loosen 3 screws on light plate as shown. Plug white wire from fan to white wire from light kit. Then plug black wire from fan to black wire from light kit. 37 Install 3 x 60 watt candelabra bulbs. Bulbs not included. Twist lower cover plate into place by twisting in direction of arrow.
43 Remote Control Transmitter Features: Attach front cover to wall control with screws provided. Snap battery cover in place. LED LIGHT MEDIUM SPEED LOW SPEED FAN OFF SETTING (Turns fan off only) FAN REVERSE (Press once to change direction of the fan)Fanmust be running to reverse. HIGH SPEED LIGHT ON/OFF SETTING AND DIMMER (Press and hold to dim light infinitively) FAN SPEED Depress “l dot” for low speed, “2 dots” for medium or “3 dots” for high. To turn fan off press square”.
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet.
6/21/06 REV.
