Owner’s Guide and Installation Manual Warning: Only blades that come with the fan are accepatable for installation. Warning: This fan uses dimmable remote controller. Do not install light kit with SBCFL (Self-Ballasted Compact Fluorescent Lamp) on this fan. 5DCR60XX Series Fan UL Model No. : AC-560DC Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: MODEL NUMBER: RETAILER ADDRESS: To register your fixture, please visit our website www.
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING READ AND SAVE THESE INSTRUCTIONS Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70-1999), including fire-rated construction. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer.
1 Before you begin installing the fan, Switch power off at Service panel and lock service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. 4 2 OUTLET BOX METHOD Warning-Risk of fire, electric shock, or personal injury.
10 Loosen the 2 set screws. You should be able to put your downrod into the yoke. 13 Tighten both yoke set screws to further secure downrod. Reinstall the downrod ball previously removed. 16 Carefully lift fan assembly onto mounting bracket. Rotate fan so that the notch on the ball engages the ridge in the mounting bracket. This will allow hands-free wiring. © 2011 Monte Carlo Fan Company 12 11 Install canopy and yoke cover over the downrod.
19 Safety cable installation 21 20 Black Safety Cable White Lag Screw Green safety cable lock washer For Canadian installation and for USA fan and light kit combinations over 35 lbs, in both flush and downrod mode the safety cable must be installed into the house structure beams using the 3” lag screws,washers, and lock washers. provided. Make sure that when the safety cable is fully extended the leadwires are longer than the cable and no stress is placed on the leadwires.
28 Install the switch housing plate by aligning the 2 screws with the 2 key slot holes on the plate and twist to lock into place. Install the 1 screw removed and tighten the other 2 screws securely. © 2011 Monte Carlo Fan Company 29 30 Remove the 3 screws on the switch housing plate and save. 6 Install the switch housing using the three screws previously removed.
Receiver learning function (dc motor) After the fan is powered (DC motor), the receiver will start sourcing the frequency in the first 30 seconds; during the time, any instruction from the transmitter (pressing any button) will be recognized and memorized as the ID frequency of the using transmitter; frequencies from the other transmitters won’t be identified as the instruction to operate your fan.
NOTE: If you have more than 1 fan with a remote, you will have to change the DIP switch settings located above the battery of the remote. There are no DIP switches on the fan. Only change the remote DIP switches. LIGHT DELAY FAN REVERSE (Press once to change direction of the fan)with fan running. When the low battery sign is shown on the LCD display, replace a new battery. Memory for fan speed.
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet.
Apr.2012 New format Sep.5.