Owner’s Manual Ceiling Fan Installation Instructions For 5DCR60XX Fan READ AND SAVE THESE INSTRUCTIONS Total fan weight
Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 1 Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 701999), including fire-rated construction. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer.
7 8 9 Lift mounting neck to mounting Plate and align screws. Secure mounting neck to the mounting plate with four screws to become a complete mounting bracket. Remove the keeper pin and cotter pin. 10 11 12 Loosen the 2 set screws. You should be able to put your downrod into the yoke. 13 Tighten both yoke set screws to further secure downrod. Reinstall the downrod ball previously removed. 16 Install canopy and yoke cover over the downrod.
19 20 Black White Green House Fan Black 21 White Green(downrod) Green(Bracket) Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the equipment-grounding conductor on one side of the outlet box and ungrounded conductor on the other side of the outlet box. 22 Place the gasket onto the blade bracket as shown above.
NOTE: If you have more than 1 fan with a remote, you will have to change the DIP switch settings located above the battery of the remote. There are no DIP switches on the fan. Only change the remote DIP switches. LIGHT DELAY FAN REVERSE (Press once to change direction of the fan)with fan running. When the low battery sign is shown on the LCD display, replace a new battery. Memory (Saves the stored settings before turned off.) Pressing the light delay button activates the light delay function.
Receiver learning function (DC motor) After the fan is powered (DC motor), the receiver will start sourcing the frequency in the first 60 seconds; during the time, any instruction from the transmitter (pressing any button) will be recognized and memorized as the ID frequency of the using transmitter; frequencies from the other transmitters won’t be identified as the instruction to operate your fan.
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet.