Owner’s Manual Ceiling Fan Installation Instructions Total fan weight For 5RDR Series Fans BLADES NOT INCLUDED READ AND SAVE THESE INSTRUCTIONS Quality Ceiling fans
Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 701999), including fire-rated construction. Use this unit only in the manner intended by the manufacurer. If you have any questions contact the manufacturer.
7 8 9 Lift mounting neck to mounting Plate and align screws. Secure mounting neck to the mounting plate with 6 screws to become a complete mounting bracket. Lower upper glass disk onto fan housing and align 3 holes in glass with 3 holes in fan housing. 10 11 12 Install 3 screws to hold glass to fan housing. Do not overtighten as this could crack the glass. Remove pin from downrod and save for later step 14. Push the yoke cover onto downrod. Thread lead wires and safety cable through the downrod.
19 20 21 Install arch mount by using screw and nut removed in step 16. Place screw through tab and tighten nut and screw securely. Align holes in arch arm and slot for tab with holes and tab on fan body. Start all screws in the arch arm brackets. Tighen all 6 screws for arch arms securely. 23 24 Push the yoke cover down into place. Plug in electrical connections there are 2 double plugs from arch assembly one for the fan and one for the up and down lights.
31 Canadian mounting only 33 32 Safety Cable Fan House black black white white orange Lag Screw For Canadian installation in both flush and downrod mode the safety cable must be installed into the house structure beams using the 3” lag screws provided. Make sure that when the safety cable is fully extended the leadwires are longer than the cable and no stress is placed on the leadwires. 34 blue Green Make wiring connections as indicated above. White from fan to white from remote marked N.
43 Attach front cover to wall control with screws provided. 44 Fan speed control buttons Light dimmer for up and down lights Fan on / off Fan reverse button To control fan speed select from High, Medium or low speed buttons. To turn the fan off press the Fan on / off button. To dim upper lights press and hold U/L botton. To dim Lower lights press and hold D/L button. To turn off either up or down light press and quickly release either U/L or D/L button.
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet.
