Instructions / Assembly

4
© 2018 Monte Carlo Fan Company
09/2018
7 8 9
10 11 12
Replace the fan housing. Align the key
holes on the housing with the preinstalled
set screws on top plate of fan body then
turn the housing clockwise till tight.
Reinstall the set screw removed in
installation step 5 and tighten all screws
securely.
Partially loosen downrod set screws from
yoke at top of motor assembly.
Remove preassembled cross pin and
keeper pin from downrod. Keep parts.
Place downrod over canopy, canopy
bottom cap and yoke cover.
Thread lead wires and safety cable from
motor assembly through downrod.
For easy installation of cross ping on next
step.
Carefully insert a phillips screwdriver through
yoke and downrod (don’t damage the lead
wires) as a guide and then push the cross
pin and pull the screwdriver in the meantime
as shown in illustration.
Cross pin
Screwdriver
Canopy
Canopy bottom cap
Yoke cover
Downrod
Cross
pin
Keeper
pin
Downrod
Yoke
re
Lead wires