Owner’s Guide and Installation Manual 3CDR56XX Series Fan UL Model NO. : 3CDR56XX Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: MODEL NUMBER: RETAILER ADDRESS: To register your fixture, please visit our website www.montecarlofans.com 8.23 kgs 18.
Cautions and Warnings WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING READ AND SAVE THESE INSTRUCTIONS Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70-1999), including fire-rated construction. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer.
1 2 3 Ceiling ON ON Ceiling Joists OFF Screw OFF 2˝ x 4˝ Mounting plate Outlet Box Before you begin installing the fan, Switch power off at Service panel and lock service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the service panel. Use AC 120V/60HZ power supply only.
7 8 Safety cable from fan White (neutral) Green/Ground Black (Live) Outlet box ttac a et Ca le to Ceilin u ort Ca le Wall switch 9 NG Power source Green/Ground White Black OK Set screw Wire Cable clamp Connect the safety cable from fan to the Ceiling support cable. Slide cable clamp onto the safety cable from fan. Place the end of cable through the loop of ceiling support cable and then feed end of cable into clamp hole and firmly tighten set screw. Cut off excess safety cable.
13 Blade Assembly Blade Assembly Screw 1/4” x 1/2” L Insert blade assembly into the base of blade bracket. Install the blade assembly to blade holder base using the screws provided (1/4 x 1/2” L). Tighten screws securely. Repeat this process for remaining blade assemblies. REMOTE CONTROL SETTING and OPERATION Remove the battery cover from the remote control transmitter and install battery. Replace the cover. Note: Use 2 1.5V/AAA battery to replace battery. (Fig.
REMOTE CONTROL SETTING and OPERATION Universal Mode and Learning Mode Dip(Code) Switches There are “Universal Mode” and “Learning Mode” with the remote controller. Upper position If choosing “Universal Mode”, simply place both dip (code) switch at UPPER position. Your fan with the remote controller is ready to use. (Fig. 3) Lower position Note: If using universal mode, your fan can be controlled with other remote transmitters with the same setting.
The receiver provides the following protective functions Lock protection- The DC motor has a build-in safety feature against blade or motor obstruction during operation. If something obstructs the fan blades or motor, the motor will keep trying to run for 3 times and then stop operation after about 30 seconds of interruption. Please remove obstacles and reset. To reset it by turn the fan off by remote transmitter and then turn the fan on.
Trouble Shooting or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning: Before servicing or cleaning unit, Switch power off at Service panel and lock service disconnecting means to prevent power from being switched on accidentally.
Sep.
