Instructions / Assembly

4
© 2015 Monte Carlo Fan Company
9/1/2015
7 8 9
10 11 12
Connect the safety cable from fan to the
Ceiling support cable.
Slide cable clamp onto the safety cable
from fan. Place the end of cable through
the loop of ceiling support cable and then
feed end of cable into clamp hole and
firmly tighten set screw. Cut off excess
safety cable.
Make sure that when the safety cable is
fully extended the lead wires are longer
than the cable and no stress is placed on
the lead wires. Keep safety cable close to
mounting plate after installation.
Note: Place wires from power supply
along the grooves on the bracket on
mounting plate.
Make wiring connections using wire
connectors provided as indicated above.
White from fan (Receiver) to White
(Neutral) from house. Black from fan
(Receiver) to Black (Live) from house.
Connect all green grounded wires to
Grounded wire from House. Make sure
that no filaments are outside of the wire
connectors.
Lift fan housing up, and snap it onto
mounting plate by pushing it up. Make sure
the groove inside the housing engage with
the humps on mounting plate firmly.
If the plate with hump is pushed upper than
mounting plate, simply use an object to
press it down to position.
Install the base of blade bracket.
Insert a Phillips screwdriver through the
hole on drive shaft as shown in drawing as
an application stick, and then install blade
holder base by turning clockwise until tight.
Tighten the 2 pre-installed set screws (M6 x
6mm Flat head socket screw) to secure the
blade bracket base with Allen wrench
provide. Make sure the set screws are fully
installed and jammed against the driver
shaft.
Install another set screw with washers from
bottom of the blade bracket base. Tighten
all screws securely.
Keep Allen wrench for future use.
Install decorative cover of the base of
blade bracket.
Align the holes on blade bracket base
with the alignment posts on decorative
cover than install 3 socket head set
screws (3/16 x 1/2” L) from top side with
4mm Allen wrench provided. Tighten all
screws securely.
Keep Allen wrench for future use.
Align the holes of blade bracket, blade
and the bottom plate of blade bracket.
Install blade bracket with blade by 3
blade screws provided. Tighten screws
securely. Repeat this process for
remaining blades.
Note: Make sure the side with a mark
“UP” is installed upward.
Blade bracket
Bottom plate
Blade set screw
Blade
Decorative cover
Allen wrench (4mm)
Socket set screw
(3/16 x 1/2” L)
Blade Holder Base
Screw 3/16”x1/2”L
Allen wrench (3mm)
Flat head socket
screw (M6 X 6mm)
Philips
screwdriver
Washer
Lock washer
OK
NG
Safety cable from fan
Cable clamp
Set screw
M6 x 6 mm L
3/16” x 1/2” L
3/16 x 1/2” L
3/16” x 1/2” L
Face UP
U P
Wire
Black
Black (Live)
White
White (neutral)
Power
source
Green/Ground
Green/Ground
Outlet box
Wall switch
ttac a et
Ca le to Ceilin
u ort Ca le
Alignment post