Installation Guide

5
© 2015 Monte Carlo Fan Company
12/2017
13 14
15
16
17
Connect white wire from fan to white wire
from LED light kit and then connect blue
wire from fan to black wire from LED
light kit.
Attach LED light kit to light pan by
locating dimples in light pan with grooves
on the LED light kit and twist clockwise
until tight.
Note: If you don’t want to install the
fan with LED light, go to step 15 for
blanking plate installation.
Remove LED module and Light shade
from Light plate as shown in illustration.
Keep screws.
Install blanking plate onto light plate using
the set screws of light shade which were
just removed.
Attach blanking plate assembly onto light
pan by locating dimples in light pan with
grooves in blanking plate and twist
clockwise until tight.
Setting the reverse switch on the left
hand side will result in downward airflow
and setting the switch on the right hand
side will result in upward airflow.
Note: Reverse switch must be set either
way completely. If the reverse switch is
set in the middle position, fan will not
operate.
LED light kit
Reverse switch
Install LED Light Kit
LED Module
Light shade
Light plate
Install blanking plate
Blanking
plate
Light plate
Blanking plate assembly
Blanking plate assembly
Light pan