Owner’s Guide and Installation Manual 3JVR58XXXD Series Fan cETL Model NO. : 3JVR58XXD Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: MODEL NUMBER: RETAILER ADDRESS: To register your fixture, please visit our website www.montecarlofans.com 7.36 kg 16.
Cautions and Warnings WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING READ AND SAVE THESE INSTRUCTIONS Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70), including fire-rated construction. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer.
1 2 ON ON OFF OFF Before you begin installing the fan, Switch power off at Service panel and lock service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the service panel. Use AC 120V/60HZ power supply only. 4 3 Before installing this fan make sure the outlet box is properly installed to the house structure.
7 8 9 Canopy Downrod Downrod Cross pin Top housing Yoke Canopy bottom cap Keeper pin Yoke cover Remove the set screws from yoke. Keep the screws. Place the top housing over lead wires, safety cable and the yoke. Replace the set screws and tighten all the screws. Partially loosen downrod set screws from yoke at top of motor assembly. Remove preassembled cross pin and keeper pin from downrod. Keep parts. Place downrod over canopy, canopy bottom cap and yoke cover.
Wall switch 13 Black Brown Grey Orange Power source White Ground/Green Receiver White Black Blue White Make wiring connections using wire connectors provided as indicated above. Brown wire from fan to Brown wire from receiver marked Motor U. Gray wire from fan to Gray wire from receiver marked Motor V. Orange wire from fan to Orange wire from receiver marked Motor W. White wire from fan marked “For light” to White wire from receiver marked “For light”.
17 18 19 LED light fixture Loosen 2 and remove 1 preassembled screw from light pan. Save screw for later use. Connect white wire from fan to white wire from LED light kit and then connect blue (or black) wire from fan to black (or blue) wire from LED light fixture. Attach LED light fixture onto the light pan, aligning the keyhole slots on the light fixture with the preassembled screws on the light pan and twist clockwise till lock. Reinstall the screw removed in step 17. Tighten all screws securely.
Remote Controller Operation Remove the battery cover from the remote control transmitter and install batteries. Replace the cover. This remote uses 2 1.5V/AAA batteries. Note: If not using for long periods of time, remove the batteries to prevent damage to remote controller, and store the remote controller away from excess heat or humidity. The batteries will weaken with age and should be replaced before they leak or corrode as this will damage the controller. Dispose of the used batteries properly.
Install Transmitter wall mount cradle with 2 screws provided. Useful tips: The remote transmitter can be removed by pressing it upward from the lower half. The remote transmitter can be held on magnetic metal materials by a magnet built in the transmitter. The receiver provides the following protective functions: Lock protection: The DC motor has a build-in safety feature against blade obstruction during operation.
Troubleshooting or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning and lock the service panel to prevent the power from being switched back on accidentally. If the service panel cannot be locked to prevent the power from being switched on accidentally, securely fasten a warning sign to the service panel. Trouble 1.
Jun.
