Instructions / Assembly

© 2011 Monte Carlo Fan Company
2/10/2012
4
Carefully lift fan assembly onto mounting
bracket. Rotate fan so that the notch on the
ball engages the ridge in the mounting br acket.
This will allow hands-free wiring.
12
Install 3 screws and washers per
blade and tighten securely. Repeat
for all 5 blades. The blades will ha ve
a label showing this side up on each
blade.
18
Make wire connections to power source
using wire nuts provided. Make sure that
no filiments are outside of the wirenut.
After making the wire connections, the
wires should be spread apart with the
grounded conductor and the equipment -
grounding conductor on one side of the out -
let box and ungrounded conductor on the
other side of the outlet bo x.
14
For pullchain controls, follow diagram above.
Make sure that all exposed wiring is secured
inside wire nuts. Note: Wires from house ma y
vary in color and ma y not include ground wire.
After wiring is conplete, gently push wires into
junction box with wire nuts pointing upw ard.
Refer to point 3 of safet y tips.
15
House
Fan
Black
White
Green
Black
White
Green(downrod)
Green(Bracket)
Blue
For control of fan and optional light from w all
location, follow diagram above. NOTE: A profes-
sional electrician is recommended for this t ype
of installation.
16
Light Switch
Fan Switch
Wall
Control
Remove screws from stabilizer plate
on bottom of fan motor.
10
11
Remove stabilizer plate you will not
need this plate.
Loosen one and remove one preassem-
bled screw from mounting bracket.
Save screw. Lift canopy up, aligning its
keyhole slot with the preassembled
screw on mounting bracket and twist
clockwise to lock in place. Re-install the
removed screw and tighten all screws
securely.
17
For Canadian installation and for USA fan and light
kit combinations over 35 lbs, in both flush and
downrod modes the safety cable must be installed
into the house structure beams using 3” lag
screws, washers and lock washers provided. Make
sure that when the safety cable is fully extended
the lead wires are longer than the cable and no
stress is placed on the lead wires.
Note:If Installing The Secondary Support Safety
Cable in the U.S., Do Not Remove Knockouts In
The Outlet Box.
1
Safety cable installation
Safety Cable
Lag Screw
safety
cable
3” lag
screw
lock
washer
washer